Change Default Vega 4x4 Configuration file

The 'Default Vega 4x4 configuration' file contains following configuration:
 

•    SIP

•    POTS

•    DIAL PLAN which defined the forward rules between SIP and TDM

Important note :

It is important to note that the 'Default Vega 4x4 configuration' file you are about to upload will overwrite your IP Addressing.

To ensure that this does not occur it is important to change the IP Address, subnet mask and Gateway information within the 'Default Vega 4x4 configuration' file to match the correct Vega gateway IP address configuration.

The 'Default Vega 4x4 Configuration' file is available on the BT Extranet site at https://www.extranet.trading-command.com/.

- Change the IP Address and Gateway Information within the 'Default Vega 4x4 configuration' file before uploading to the new Vega4x4 or existing Vega4x4 gateway.

Here are the steps to change the information within the Default Vega 4x4 configuration file:

 
1.Open the Config file

2.Locate and replace the following configuration with the correct network information and then save the file:
 

- VEGA IP ADDRESS

- VEGA SUBNET MASK

- VEGA DEFAULT GATEWAY

- VEGA DEFAULT DNS