Prerequisites

The discussion below assumes that

•CUCM 8.0 or higher must be installed and fully functional and specifically,

•IPTrade Profile EK/TAD device definition must have been loaded in the CUCM database ;

•IPTrade TSS 10.1 and TPO 10.1 must be installed and fully functional

•TPO run-time has been installed on host  system (see TPO Install Guide) ;

•TPO devices, and empty TPO clusters have been defined in the TSS  (see TPO Install Guide) ;

•TPO service is reported as alive in TSS console - See panel System | Sessions | Device sessions ;

•Being familiar with the TPO and turret connection topics

•Being familiar with TPO Places and TPO GroupID concepts

•Two turrets must be installed and registered onto the TSS  ;

Please refer to the diagram here above for the various identifiers, names, IP addresses… which have been considered when writing the installation instructions below.