Configure

Set settings in one of following section:

•Device Management / Turrets / Edit Turret / Turret Boot Settings / Advanced Mode

•Device Management / Zones / Edit Zone / Turret Boot Settings / Advanced Mode

•System / Models / Edit Model / Settings / Basic Mode / Advanced Mode

Enable the settings below:

Location: Terminal Boot Settings
Global	Allow standalone boot truefalse Key: application.boot.allowstandalone Description: Defines if the Bootstrap will try to boot in standalone mode (using data stored on the backup drive) in case of TFTP loss. Should not be edited manually. Constraint: true|false Related settings: Standalone boot drive (application.boot.standalonedrive) Standalone survive to all errors (application.boot.standalone.surviveall)

Location: Terminal Boot Settings
Global	Standalone survive to all errors truefalse Key: application.boot.standalone.surviveall Description: Defines if the turret will try to boot in standalone mode if the TSS returns an error. This allows to survive even when the TSS is up but returns errors. Constraint: true|false Related settings: Allow standalone boot (application.boot.allowstandalone)

The setting below is also available to change the local database backup location, especially useful on the FlexPro or FlexCom:

Location: Terminal Boot Settings
Global	Standalone boot drive Key: application.boot.standalonedrive Description: Defines the drive used in standalone mode to store and retrieve data in case of TFTP loss. Should not be edited manually. Constraint: String, must be a valid drive Related settings: Allow standalone boot (application.boot.allowstandalone)