Hand device usage

User Options > Peripheral devices > Wireless Push To Talk > Usage

Once the WPTT device is properly paired, pressing Hand Device button transmit Speak events to the turret.

•Pressing the Hand Device button activates Speak Action Button

•Releasing the Hand Device button deactivates Speak Action Button

•It can also work in combination with the Audio Selector Button (On the fly audio redirection)

Note that there's not need to configure a Speak Action Button in user interface to make the WPTT works.

ie : I have 3 radio channels monitored on a monitor applet. When I select one channel by pressing the select button, I can press the wireless device to start transmitting

Signal transmission status

Transmission LED of the hand-device indicates signal transmission status:

Button pressed	LED State	Description
Yes	Steady red	Hand-device successfully sends applicative messages to the WPTT base
Yes	100ms orange/red blink	Hand-device has failed to send an applicative message to the WPTT base
No	100ms orange blink every 3s	No pairing information available, device should be paired

Charging hand-device

Hand-device is powered through an embedded battery.

The battery has 18 hours autonomy and can be charged within 2 hours.

IP Trade recommends to charge the hand-device battery using provided USB cable.

Note – when charging the clip on “hand-device” on a turret with the “USB” base connected – the 2 units will pair

Power LED of the hand-device indicates battery charge status:

USB connected	LED State	Description
No	100ms green blink every 3s	The battery has a good level
No	100ms orange blink every 3s	The battery level is down, it should be recharged
Yes	500ms green blink every 1s	The battery is charging
Yes	Steady green	The battery is fully charged