Handsets

You can use the following handsets with Netrix:

Netrix standard handset

It provides traditional controls for volume which is set to push-to-mute (PTM) (by default) or can be configured to support push-to-talk (PTT) operation. The following Netrix-3 noise-cancelling handset type is supported.

Volume control

A scrolling wheel is positioned along the edge of your handset. Rotate the wheel to either increase or decrease the volume level of incoming speech.

Push-to-mute (PTM) switch

By default, the Netrix standard handset is always configured so that the switch operates in Push-to-Mute (PTM) mode. The push-to-mute switch is positioned in the handle of your handset. It stops your voice from being transmitted over the mouthpiece.

push-to-mute (ptm)

To temporarily mute transmitted speech:

Hold down PTM switch

message muted

…in handset status field

When finished:

release PTM switch

push-to-talk (ptt)

Your Netrix handset can be configured so that the switch operates in Push-to-Talk (PTT) mode. You need to speak to your Platform Administrator if you want to use the handset in this mode.

To temporarily transmit speech:

Hold down PTT switch

When finished:

release PTT switch

message muted

…in handset status field

Rocker Switch

The rocker switch is positioned on the back of the Netrix handset behind the earpiece. If set to on, it stops transmission of your speech via the mouthpiece until the switch is turned off.

press rocker switch

message muted

…in handset status field

To remove:

press rocker switch

…again to turn off