Networking > Network, OPUS codec support > Configure
IT & voice administrators must proceed as follows
1.Get the Opus dynamic type payload value from the network infrastructure manager
2.Connect to the TSS administration console from your preferred Internet navigator and log onto the system with administration privileges
3.From the main menu, click on Device Management and select your TPO cluster;
4.From the TPO cluster menu, click on Settings and open the Media panel
5.Check List of supported codec option and add in Opus codec; the added value must be in the form
<payload type number>, <codec name>, <clock rate >, <optionalcodec param>
For Opus, codec name is opus, clock rate is 48000and the dynamic payload type is obtained by the step 1 (default value is 114)
Example: 114, opus, 48000
Location: TPO Boot Settings
Media
List of supported codecs
Key: application.mm.nvsupportedcodecs
Description: This is a semicolon separated list giving the list of codecs including DTMF payload type the turret will support. These value will be used to negotiate a call and should be accurate especially for DTMF payload value that may prevent some PBX to handle the call properly if not set to the right local value. Valid RTP payload number are 0 (G711µ),8(G711a),9(G722) and dynamic payload number(PBX dependant) associated to iLBC codec (default is 116), L16 codec (default is 108) and Opus codec (default is 114). The way you order the list will change the priority given to a specific codec.
